Brand | D-Link |
---|
Model | DSL-224 |
---|
Category | Modems & Routeurs |
---|
Standards | IEEE 802.11b/g/n |
---|
Frequency range | 2400 ~ 2483.5MHz |
---|
Wireless connection security | - WEP
- WPA/WPA2 (Personal/Enterprise)
- МАС filter
- WPS (PBC/PIN)
|
---|
Advanced functions | - WMM (Wi-Fi QoS)
- Information on connected Wi-Fi clients
- Advanced settings
- Guest Wi-Fi / support of MBSSID
- Limitation of wireless network rate
- Periodic scan of channels, automatic switch to least loaded channel
- Autonegotiation of channel bandwidth in accordance with environment conditions (20/40 Coexistence)
|
---|
Wireless connection rate | - IEEE 802.11b: 1, 2, 5.5, and 11Mbps
- IEEE 802.11g: 6, 9, 12, 18, 24, 36, 48, and 54Mbps
- And IEEE 802.11n: from 6.5 to 300Mbps (from MCS0 to MCS15)
|
---|
Transmitter output power | - 802.11b 15dBm (+/-1dB)
- 802.11g 14dBm (+/-1dB)
- 802.11n 14dBm (+/-1dB)
|
---|
Receiver sensitivity | - 802.11b – 86dBm
- 802.11g – 72dBm
- 802.11n
- HT20 – 67dBm
- HT40 – 65dBm
|
---|
Modulation schemes | - 802.11b: CCK (11, 5.5Mbps), DQPSK (2Mbps), DBPSK (1Mbps), DSSS
- 802.11g: PSK/CCK, DBPSK, DQPSK, OFDM, BPSK, QPSK, 16QAM, 64QAM
- 802.11n: PSK/CCK, DBPSK, DQPSK, OFDM, etc.
|
---|
Physical Parameters |
---|
Dimensions (L x W x H) | 205 x 139 x 32 mm (8 x 5.5 x 1.3 in) |
---|
Weight | 260 g (0.6 lb) |
---|
Operating Environment |
---|
Power | Output: 12V DC, 1A |
---|
Temperature | - Operating: from 0 to 40 °C
- Storage: from -20 to 70 °C
|
---|
Humidity | From 5% to 95% (non-condensing) |
---|
Delivery Package | - Router DSL-224
- Power adapter DC 12V/1A
- RJ-11 telephone cable
- Ethernet cable
- Splitter
- “Quick Installation Guide” (brochure)
|
---|
Hardware |
---|
Processor | RTL8685S (500MHz) |
---|
RAM | 32MB, DDR2 SDRAM |
---|
Flash | 8MB, SPI |
---|
Interfaces | - RJ-11 DSL port
- 4 10/100BASE-TX LAN ports
|
---|
LEDs | - POWER
- INTERNET
- DSL
- 4 LAN LEDs
- WLAN
- WPS
|
---|
Buttons | - POWER button to power on/power off
- RESET button to restore factory default settings
- WPS button to set up wireless connection
- WIFI button to enable/disable wireless network
|
---|
Antenna | Two external non-detachable omnidirectional antennas (5dBi gain) |
---|
MIMO | 2 x 2 |
---|
Power connector | Power input connector (DC) |
---|
DSL Parameters |
---|
VDSL/ADSL Standards | - VDSL2: ITU G.993.2, support of 8a, 8b, 8c, 8d, 12a, 12b, 17a, 30a profiles
- ADSL: Multi-mode, ANSI T1.413 Issue 2, ITU-T G.992.1 (G.dmt) Annex A, ITU-T G.992.2 (G.lite) Annex A, ITU-T G.994.1 (G.hs)
- ADSL2: ITU-T G.992.3 (G.dmt.bis) Annex A/L/M, ITU-T G.992.4 (G.lite.bis) Annex A
- ADSL2+: ITU-T G.992.5 Annex A/L/M
|
---|
ATM/PPP Protocols | - Bridged and routed Ethernet encapsulation
- VC-based or LLC-based multiplexing
- ATM Forum UNI3.1/4.0 PVC (up to 8 PVCs)
- ATM Adaptation Layer Type 5 (AAL5)
- ITU-T I.610 OAM F4/F5 loopback
- ATM QoS
- PPP over ATM (RFC 2364)
- PPP over Ethernet (PPPoE)
- Keep-alive for PPP connections
|
---|
Software |
---|
WAN connection types | - PPPoA
- PPPoE
- IPv6 PPPoE
- PPPoE Dual Stack
- IPoA
- Static IPv4 / Dynamic IPv4
- Static IPv6 / Dynamic IPv6
- Bridge
|
---|
Network functions | - DHCP server/relay
- Advanced configuration of built-in DHCP server
- Stateful/Stateless mode for IPv6 address assignment, IPv6 prefix delegation
- DNS relay
- Dynamic DNS
- Static IP routing
- Static IPv6 routing
- IGMP Proxy
- IGMP snooping
- RIP
- Support of UPnP IGD
- Support of VLAN
- WAN ping respond
- Support of SIP ALG
- Support of RTSP
- LAN/WAN conversion
|
---|
Firewall functions | - Network Address Translation (NAT)
- Stateful Packet Inspection (SPI)
- IPv4/IPv6 filter
- MAC filter
- URL filter
- DMZ
- Prevention of ARP and DDoS attacks
- Virtual servers
- Built-in Yandex.DNS web content filtering service
|
---|
VPN | IPsec/PPTP/L2TP/PPPoE pass-through |
---|
QoS | - Interface grouping
- VLAN priority (802.1p)
|
---|
Management and monitoring | - Local and remote access to settings through TELNET/WEB (HTTP/HTTPS)
- Multilingual web-based interface for configuration and management
- Support of D-Link Assistant application for Android and iPhone smartphones
- Firmware update via web-based interface
- Automatic notification on new firmware version
- Saving/restoring configuration to/from file
- Support of logging to remote host
- Automatic synchronization of system time with NTP server and manual time/date setup
- Ping utility
- Traceroute utility
- TR-069 client
|
---|